Every batch of precision turned parts goes through first-article, in-process and outgoing inspection — standard tolerance ±0.01 mm, with tight features controlled down to ±0.005 mm.
Only equipment currently in use is listed as available. Coordinate measuring capability is planned, not yet in service.
Outside-diameter and thickness measurement of turned diameters and features.
Height, step and position checks on prismatic and turn-milled features.
Surface roughness (Ra) verification where a finish requirement is called out.
Optical checks of small profiles, edges and features difficult to gauge by contact.
Coordinate measuring capability is planned — please ask for current status if your project requires CMM reports.
CMM plannedInspection is staged through production so non-conformance is caught early and nothing ships unverified.
The first completed part is checked fully against the drawing before the batch continues — first-article approval can be shared with you on request.
Operators and inspectors check key dimensions during the run to hold tolerance as tools wear and batches progress.
A final dimensional and visual check, plus count and packing review, is completed before parts leave the factory.
Dimensional inspection reports and material certificates / mill test reports are supplied with shipment on request — state the requirement when ordering.
Standard ±0.01 mm, tight features down to ±0.005 mm. ISO 9001 and other certification status on request — please confirm current status rather than assuming certification.
Send your drawing and note the reports or material certificates you need. We'll confirm the inspection plan and quote within 24 hours on working days.